![]() 100” is still doable, but you lose some contrast, and you might need to crank brightness up a little. In my testing, the picture is great at 80" and lower when used in the dark. BenQ says input latency is around 22ms, but my own testing using it as an external display from my laptop indicates somewhere around 6 frames of lag at 60Hz or around 100ms, though that could be specific to the Displayport Type-C input, or other factors may have been at play. I didn’t notice any substantial or distracting lag between the picture and the audio when using the built-in apps, as sometimes happens with projectors. And while it isn’t bright enough for use in direct sunlight, the GS50 did fine when set up in the shade of my honestly quite sunny cabin deck. I spent most of my time using it in the 65-80” range and found the image to be sharp given the price and the use case, but obviously less sharp than an at-home 4K TV of a similar size. Ultimately, it’s up to you if 1080p is suitable for the image sizes you need. ![]() In software, it can take up to a 4K resolution or as low as a 480p picture, downscaling or upscaling as necessary to fit within the 1080p resolution. I wouldn’t trust this sort of rating much past that, though.Ī daytime worst-case example in "low-power" mode. These “light” IP ratings are harder to test, but I did splash the top of the unit with a bit of seltzer and allowed it to drip down the sides, and it didn’t die. The top cover for the Android TV dongle also has a gasket that protects it (though mine falls out easily when opening the top cover), and BenQ says the side ports for the speaker have a film of some kind inside to reduce water damage. That means you shouldn’t use it in the rain, even if it’s just a light drizzle. Unless it’s a really quiet/suspenseful title, it probably won’t be an issue, but you will notice it if things are quiet, and it gets louder depending on the picture mode - “low power” is less noisy than “normal.”īenQ says the GS50 projector is “splashproof” with an IPX2 rating. But while content is being played, you can’t hear it over things like dialogue or ambient movie noises. If nothing is being played, you’ll notice it immediately, though it can blend in as white noise after a while. ![]() Like most projectors, there’s a built-in fan.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |